Bus Overhead Gauge Panel

Bus Overhead Gauge Panel

This overhead fiberglass gauge housing is designed to fit all busses 1955-1967. It mounts to the underside of your fresh air box, and offers a view of your three most important gauges, rear view mirror... Click here for more information

Starting at: $49.95


selector rod Shift Ball (Type 2)

This plastic ball goes in the nose cone of a 68-79 bus transmission. There isn't a good way to tell if yours is worn out other than taking the nose cone off, but before taking it off, make sure your trans is in neutral. As you pull the nose cone off, push the hockey stick through it as you go. Now pull the hockey stick out of the ball. Turn the ball sideways in the selector rod and pull it out. Take the new ball, grease it with some white grease and install it in the selector rod. Put a new gasket on the transmission housing and slide the hockey stick just past the nose cone mating surface. Engage the hockey stick into the ball and slide the nose cone on the rest of the way and tighten it.

selector rod Shift Ball
Add to cart

Plastic

68-79

This plastic ball goes in the nose cone of a 68-79 bus transmission. There isn't a good way to tell if yours is worn out other than taking the nose cone off, but before taking it off, make sure your trans is in neutral. As you pull the nose cone off, push the hockey stick through it as you go. Now pull the hockey stick out of the ball. Turn the ball sideways in the selector rod and pull it out. Take the new ball, grease it with some white grease and install it in the selector rod. Put a new gasket on the transmission housing and slide the hockey stick just past the nose cone mating surface. Engage the hockey stick into the ball and slide the nose cone on the rest of the way and tighten it.
002 301 241A: $6.60