Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:There are 93 products.
Part #: 112950505IDF
Throttle Shaft Lock Tab Washer for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 112950506IDF
Throttle Shaft Nut for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 112950507IDF
Pump Jet Washer for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129508
These are some of the most common jets used.
Application:Part #: 1129510
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129515PR
Linkage Down Rod Extensions, Short & Long, Pair
Application:Part #: 1129516
Empi Hex Bar Linkage Bearing Conversion Kit
Application:Part #: 1129517
Linkage Ball End Bushings, Pair
Application:Part #: 1129510A
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1198578
This kit has the gaskets, o-rings, accelerator pump and needle and seat to rebuild an IDF carb.
Application:Part #: 1129802
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129310
Empi Idle Jet Vent Tube Kit
Application: