Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This kit allows you to run disc brakes in the rear.
This kit allows you to run disc brakes in the rear. We suggest you buy the front kit first, before you buy the rear kit. 70% of you braking comes from the front. This kit's a nice way to complement the front kit and it's a bolt-on application. If you have an off road car then you would only want rear disc brakes.
Bug (Type 1): 68-79
Type 3: 68-74
Ghia: 68-74
Thing: 73-74
Race/Off-Road: 68-79
No customer reviews for the moment.
Part #: 1615106C
Replacement Front Brake Rotor 5/205, 12x1.5mm, Swing Axle for Kit 1615100F
Application:Part #: 1127025A
This electric pump replaces your stock pump.
Application:Part #: 111805351A
Front Hinge Pillar, 2 hinge Screws
Application:Part #: 1198160
These rings are cast iron.
Application:Part #: 2611011
This kit allows you to run a 71-79 bus master cylinder on a pre 66 bus.
Application:Part #: N141174
Rear Side Marker Lens Mounting Screws, License light lens Screws, Sold as a Pair
Application:Part #: 113415585A
Upper Steering Column Ball Bearing
Application:Part #: 1109341EA
Push Rod Tubes, Adjustable Big-Mouth, Each
Application:Part #: 113853641A
This is the little grill that is on the front fenders of 67 and earlier Bugs.
Application:Part #: 1105254BK
This is a crank pulley for an upright motor.
Application:Part #: 111411027
Torsion Bar Set, 2 Required
Application:Part #: 111813155
Metal Channel for Engine to Body Seal
Application:Part #: 113845121BAM
This seal goes around the front window.
Application:Part #: 1412032A
This is the only correct way to lower the front end of a Super Beetle.
Application:Part #: 1831000
These fit on the front doors giving a little shade.
Application:Part #: 6857636
Weld on Dash Grab Handle. Raw Finish
Application: