Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:These are some of the most common jets used. Sold in pairs.
These are some of the most common jets used. We'll be happy to help you with your jetting, but we'll need to know some details. So before you call us, get some information ready about your engine, like size, compression ratio, etc. Sold in pairs.
No customer reviews for the moment.
Part #: 1129505002
These are some of the most common jets used.
Application:Part #: 1129516
Empi Hex Bar Linkage Bearing Conversion Kit
Application:Part #: 112950502IDA
Stack Hold Down Screw and Washer
Application:Part #: 111129493A
Steel Vacuum Line junction between Vacuum Advance and carburetor
Application:Part #: 1129199040
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.40
Application:Part #: 1129306075
These are some of the most common jets used.
Application:Part #: 1129139
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1129199050
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.50
Application:Part #: 1129040E
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129511B
Kadron Carburetor Linkage Ball Socket Ends, 10/32 Left & Right, Pair
Application:Part #: 1129033
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 113129027H
This is what delivers gas and air to the engine.
Application:Part #: 112950504IDF
Idle Jet O-ring for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 111198569A
This kit comes with the gaskets, the needle and seat, and accelerator pump diaphragm for the carburetor..
Application:Part #: 1129027
This raises a stock 28/30PICT carburetor to clear the 12 volt alternator or generator..
Application:Part #: 1129040
We've found that dual carbs work better than any single carburator set up.
Application: