Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This kit contains most of the seals and gaskets necessary to rebuild an engine.
This kit contains most of the seals and gaskets necessary to rebuild an engine. You'll also need to purchase a flywheel seal. If your case is a dual relief motor, you'll also need another copper o-ring for the second relief plug and two more of the oil cooler seals. Note: We use a sealer called Gasgacinch on all our gaskets.
Bus (Type 2): 79
Vanagon: 80-83
No customer reviews for the moment.
Part #: 111198007AF
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 113101157C
This plug goes in the back of the case (flywheel side).
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1198035
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 040101149
Oil pick up Pipe
Application:Part #: N144031
Some of the most common studs you might need.
Application:Part #: N110062
Some of the more common nuts you might need..
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1101131
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 043101025
We only carry NEW dual relief cases. Limited supply!
Application:Part #: N105001
These are the bolts that hold the engine in.
Application:Part #: N110104
Some of the more common nuts you might need..
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111198005
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application: