Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This kit contains most of the seals and gaskets necessary to rebuild an engine.
This kit contains most of the seals and gaskets necessary to rebuild an engine. You'll also need to purchase a flywheel seal. If your case is a dual relief motor, you'll also need another copper o-ring for the second relief plug and two more of the oil cooler seals. Note: We use a sealer called Gasgacinch on all our gaskets.
Bug (Type 1): 55-60
Bus (Type 2): 55-59
Ghia: 55-60
No customer reviews for the moment.
Part #: N110104
Some of the more common nuts you might need..
Application:Part #: 1101113KT
This kit has all the oil galley plugs in it.
Application:Part #: 1115107
This tray keeps the oil in the engine case from moving around too much, reducing oil starvation.
Application:Part #: 040101157
This plug goes in the back of the case (flywheel side).
Application:Part #: N144111
Some of the most common studs you might need.
Application:Part #: N104701
These are the bolts that hold the engine in.
Application:Part #: 1101132
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 111198005
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 111101191
25/36 HP Engine Case/ Generator Gasket
Application:Part #: N105001
These are the bolts that hold the engine in.
Application:Part #: 1198035
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: N145431
Some of the most common studs you might need.
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: 1101131B
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application: