Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:Guide Sleeve
This is the throw out bearing guide sleeve that bolts around the main shaft. This is what the bearing rides on. It is only used on 1971 on transmissions. They do not go bad normally.
No customer reviews for the moment.
Part #: 311141031D
This disc transfers the power from the motor to the transmission.
Application:Part #: 1141028
Kennedy Stage 4, 3000 LB Pressure Plate
Application:Part #: 1141701B
This heavy duty arm is a good idea if you need a new clutch arm.
Application:Part #: 113141723
This spring returns the clutch arm.
Application:Part #: 113141723C
This spring returns the clutch arm.
Application:Part #: 111141719F
Clutch Cable Arm Forged for 20mm Cross shaft
Application:Part #: N102401
This is a list of the most common bolts used on a car..
Application:Part #: 113141701E
This shaft holds the throw-out bearing in place.
Application:Part #: 1198026
This kit contains a quality brass bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:Part #: 1141025CH
HD Pressure Plate 1700 lbs China
Application:Part #: 113141701C
This shaft holds the throw-out bearing in place.
Application:Part #: 111721329
Clutch Pedal Shaft Bracket
Application:Part #: 1141025
Heavy Duty Clutch Pressure Plate - 1700lbs. This is made by KEP
Application:Part #: 131141719HDL
Clutch Cable Arm Forged for 16mm Cross shaft
Application:Part #: 1141701A
This heavy duty arm is a good idea if you need a new clutch arm.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application: