Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:It's really a bolt, but that's what everybody calls it.
It's really a bolt, but that's what everybody calls it. This bolt holds the flywheel on. If you are using an old one make sure the needle bearings in the pilot bearing are still in the end and that it's not rusted. Note: This bolt should be put on with a torque wrench and not a breaker bar with someone jumping off the roof. Impact guns are out too! Torque the bolt to 250 ft. lb., anything less and it will come loose. Anything more and you run the risk of cracking the bolt and having the flywheel fall off.
Bug (Type 1): 61-79
Bus (Type 2): 60-71
Type 3: 62-73
Ghia: 61-74
Race/Offroad: 61-79
No customer reviews for the moment.
Part #: 111198455
Main Bearings, 25-36 HP
Application:Part #: 111105235A
These are the shims that set the endplay of the distributor drive gear.
Application:Part #: 111105245
This seal goes behind the flywheel.
Application:Part #: 1105402
I-Beam Rod, 5.500", VW Journal 2.165"/55mm (EMPI 3/8" Rod Bolts), Set of 4
Application:Part #: JC86050
Jaycee Billet 7" Crank Pulley for Street Cars, Black
Application:Part #: 111105259
The bolt and washer that holds the crankshaft pulley on.
Application:Part #: 111105433
Wrist Pin Bushing.
Application:Bug (Type 1); 40hp
Bus (Type 2); 40hp
KG; 40hp
Part #: 111105227
Retaining Clip, 1200-1600cc
Application:Part #: 1105178
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
Application:Part #: 111105233
This gear matches up with the brass gear that is on the crank.
Application:Part #: 311105273ARC
These flywheels have been reconditioned and are sold on an exchange basis.
Application:Part #: 1105279
This gasket is only used if you're having problems with your end play.
Application:Part #: JC86070
Jaycee Billet 7" Crank Pulley for Street Cars, Silver
Application:Part #: 1105253BK
This is a crank pulley for an upright motor.
Application:Part #: 1105255BK
This is a very nice pulley; the numbers are etched in and do not wear off.
Application:Part #: 1105271
If your are going to run a 69mm or a 78 mm counterweighted crank, then you will want to have your flywheel 8 doweled or get a flywheel has been 8 doweled.
Application: