Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This is the mechanism that makes the window go up and down.
This is the mechanism that makes the window go up and down. Getting the mechanism out is a pain. You will have to start by taking the door panel off and then disconnect the glass from the regulator. Now you're ready for the tough part. The vent wing post has to come loose so look for a bolt holding it to the inner skin of the door. Pay attention to how the regulator is installed in this area, as you will want to put it back the same way. Note: We lay the regulator down flat before installing, squirt some Triflow on the cable and then roll it up and down a few times. This will help the regulator last longer.
Bug (Type 1): 75-77
Off-Road: 75-77
No customer reviews for the moment.
Part #: 113845321AAM
This seal goes around the side window that is stationary (does not have a frame).
Application:Part #: 321419779
This bushing goes around the steering shaft up by the steering wheel.
Application:Part #: 231068001
Westfalia Pop-Top Trim
Application:Part #: 1800103B
This is the "D", for Deutschland or Germany, plate of origin for that Euro look.
Application:Part #: 211843406E
Lower Sliding Door Bracket
Application:Part #: 311721509
This will replace a worn out pivot for the stock accelerator assembly, to replace this pivot you will have to remove the whole pedal assembly.Make sure you use some white grease on the pin where it mounts to the pedal to insure that it lasts longer..
Application:Part #: 111857233A
Radio Block off Plate, without chrome strip and clips
Application:Part #: 2501603
We make wheel adapters for some of the more common drums and wheels.
Application:Part #: 311109601
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 211611069C
This hydraulic slave cylinder is found in the front brake backing plate.
Application:Part #: 211405421BB
Kits contain the pins, bearings and shims which attach the spindle on king and link front ends to the axle beam.
Application:Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 6601035BK
Bead Lock Ring, No Hardware, Matte Black
Application:Part #: 6857701
It's the law and besides you really do want a good set of seat belts if you going to be out playing..
Application:Part #: 113301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 1129809K
Kadron Air Cleaner Base Gasket (Pair)
Application: