Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:These joints are located in the ends of the control arms.
These joints are located in the ends of the control arms. You will need a press and some special tools to replace the joints on a standard Bug. Note: Remove the boot before you press the joint in the arm and then put it back on after. There are four ball joints per car on a standard Bug. Super Beetle ball joints just bolt on and there is only one per side.
No customer reviews for the moment.
Part #: 113857553
Mount Rod for Right Visor
Application:Part #: JC22210
Jaycee Billet Oil Cap with Breater #8 AN Fitting, Red
Application:Part #: 111945263F
Taillight Bulb Holder, each
Application:Part #: 1615106
This kit allows you to run disc brakes in the rear.
Application:Part #: 002141701A
This shaft holds the throw-out bearing in place.
Application:Part #: 6703113B
The offset hole location of the padding allows it to be positioned to provide more protection where you want it.
Application:Part #: 151831449BK
These plastic plugs hide the door hinge screws.
Application:Part #: 151857641CBK
Dash Handle, Black with Hardware
Application:Part #: 1905530VA
The points we get today, aren't what they used to be, so the Compufire is the best way to go.
Application:Part #: 1115458
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: N102401
This is a list of the most common bolts used on a car..
Application:Part #: 261829575
These rubber buffers go on the gates and body of single and double cab Buses to prevent the gates from banging into the body.
Application:Part #: 151871351A
These strips screw to the top.
Application:Part #: F1863
These are the glues and oils we use..
Application:Part #: 1198092A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 211301265
These rubber mounts hold the transmission in place.
Application: