Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This pin and its bushings are housed on the front side of the front axle beam in a box.
This pin and its bushings are housed on the front side of the front axle beam in a box. To check for wear, have a friend turn the steering wheel back and forth while you place your hand on the top of the arm that is attached on the pin. If you feel the arm moving up and down before it spins then it needs to be replaced. On buses up to 1967 the new bushing will need to be reamed to size, once installed. We can rent you a tool that makes this job real easy on all busses to 1979. Note: If you are going to install these with out the tool it is very important that the bottom bushing be pressed in flush and the top bushing stick out .040".
Bus (Type 2): 55-67
No customer reviews for the moment.
Part #: 113845121BCL
This seal goes around the front window.
Application:Part #: 111198029
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 211883405
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: 211711182
This bushing wraps around the front shift rod.
Application:Part #: 1407183
This is almost a must for Super Beetles.
Application:Part #: 113701605
This is the gasket that goes around the floor pan between the body and the pan.
Application:Part #: 211798003
Rear Bumper Bolt Kit
Application:Part #: 1601103B
Xtra Long Wheel Studs M14-1.5, 57mm Wheel Side, 10mm Rotor side. Set of 5
Application:Part #: 1101356
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 141857509
Mirror Base Seal (set of 2)
Application:Part #: 151871182CBK
Quarter Hinge, Cover, Black Plastic Convertibles only
Application:Part #: 211255719F
Heater Tube Insulating Cover, Pipe to Heater Box
Application:Part #: 1405311
Do you have a lowered beam now? They should have come with a kidney belt and a mouth guard. These spindles will give you the stock ride and give you that lowered stance. They are sold on an exchange basis and come with new king pins and link pins. Ready for you to install. If you would like to order these before sending your old arms in, please add part...
Application:Part #: 2711100
Gear shift extensions angle back and add about 5" of length to your stock shifter, which allows you to reach the shifter without leaning forward..
Application:Part #: 6405627
Replacement Inner Bearing
Application:Part #: 311101353A
New single port head.
Application: