Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This seal goes between the handle and the body.
This seal goes between the handle and the body. The door handle must be romoved to replace them.
Bus (Type 2): 64-68
No customer reviews for the moment.
Part #: 2301150
This is a bolt on kit that reduces torsional stress felt at the front of the nose cone mount and rotational stress on the bell housing mounts.
Application:Bus (Type 2); 56-67
Part #: 111301289
Nose Cone Boot
Application:Part #: 113611057B
This hydraulic slave cylinder is found in the front brake backing plate.
Application:Part #: 1129048AE
EMPI Dual 48 IDA Carburetor Kit
Application:Part #: 211801051JR
This area tends to rust.
Application:Part #: 1615100A
This kit allows you to bolt disc brakes onto your Bug king and link pin or ball joint front end.
Application:Part #: 113853505C
This is the front strip that goes down the front hood.
Application:Part #: 6721356A
Slave Cylinder Trans Bracket for Type 1 Transmissions
Application:Part #: 211957801F
This cable goes from the speedo to the driver side front wheel.
Application:Part #: 211711423
E-Brake Handle Escutcheon
Application:Part #: 111721529A
Accelerator Pedal Pin Kit
Application:Part #: 029141025B
The clutch cover is also known as a pressure plate.
Application:Part #: 1707135BBK
This is one of the original bumper options that was used on the first Cal-Look Bugs back in the 70's.
Application:Part #: 2141701B
This heavy duty arm is a good idea if you need a new clutch arm.
Application:Part #: 113611764B
These are the metal brake lines found throughout the car.
Application:Part #: 6707102
These bumpers are made for Baja Bugs.
Application: