Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:Rear Brake Drum, Bus b M14x1.5 Threads
Rear Brake Drum, Bus M14x1.5 Threads
Bus (Type 2): 68-70 Rear
No customer reviews for the moment.
Part #: 113609205A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 211609209A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 211611477A
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 211611483
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 211698291
This kit is for rebuilding the wheel cylinder.
Application:Part #: 211611047C
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 113609163
You will find this little plug in the backside of the rear backing plates on cars 1968 and later.
Application:Part #: 211698003A
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 211609537E
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 211611047CGR
Rear Wheel Brake Cylinder, GERMAN
Application:Part #: N0120561
Accelerator Rod, Clip, 1 required
Application:Part #: 1115464
This air filter is made to protect the crankcase.
Application:Part #: 1498051A
Link Pin Shims for 7/8" Link Pins Set of 5
Application:Part #: 1129306065A
These are some of the most common jets used.
Application:Part #: 111881363
This is the padding that sits on top of the springs of the seat.
Application:Part #: 6800100
This bracket with a light above it, can be mounted anywhere in the rear of the car..
Application:Part #: 1141033
Cushion Clutch Disc - 200mm
Application:Part #: 6801101
These tabs are used for mounting just about anything to tubing..
Application:Part #: 113827902
License Plate Bracket
Application:Part #: 111863701
This is a full carpet kit.
Application:Part #: 1707135BCH
This is one of the original bumper options that was used on the first Cal-Look Bugs back in the 70's.
Application:Part #: 411945235
This seal goes between the tail light housing and the body of the car..
Application:Part #: 113853535B
This is the chrome trim that went on the front and sides of the Bug to dress it up.
Application:Part #: 6711176
This is a great kit, because it allows you to adjust the shift rod not only side to side but also in and out.
Application:Part #: 211711199
Rear Shift Rod bushing.
Application:Bus (Type 2); 50-58 vin 306725