Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This is the cool rear brake light that came on 50-56 buses.
This is the cool rear brake light that came on 50-56 buses. It is held in by two small phillips screws. This lens is plastic.
Bus (Type 2): 50-56
No customer reviews for the moment.
Part #: 211817517
Gutter above Front Left Door
Application:Part #: 6945200
These chrome steel bolt-on covers go right over the existing lense to give your tail lights "billet" look protection..
Application:Part #: 311405661
Thrust washer.
Application:Part #: 211798005A
Splash Pan Install Kit
Application:Part #: 1301265L
Urethane Front Transmission mount with Hardware
Application:Part #: 111711535
Choke Cable Grommet
Application:Part #: 113609440E
Brake Backing Plate, Right Rear
Application:Part #: 1800100R
This is a copy of the original EMPI license plate frame made years ago.
Application:Part #: 1117100
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 211809585C
Rocker Panel, Lower Left
Application:Part #: 6701061
The skid plate protects the motor and trans.
Application:Part #: 211837257A
Door check rod pin
Application:Bus (Type 2); 68-79
Part #: 6251003IN
A stinger (depending on your motor combo) makes horsepower at 5K RPM and above.
Application:Part #: ECP12Y
ECP part numbers are for the regular crimp style electrical ends.
Application:Part #: 113903515
These are the bearings and brushes for your generator.
Application: