Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:
This pin is a must because it holds the axle nut on.
This pin is a must because it holds the axle nut on. It will not prevent a loose nut from ruining a drum, but it will keep the wheel on the car. We recommend tightening the axle nuts to 250 ft. lb., drive the Bug around the block and retighten the axle nut. Drive the Bug around the block again. If the nut moves when you torque it, drive around the block again. When it no longer moves, install the cotter pin. If the hole doesn't line up, tighten it up to the next hole. Whatever you do, don't loosen the axle nut to make the pin fit. Air wrenches DO NOT let you skip the trip around the block.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 6801241
Billet Universal Mount for 1 3/4" Tubing
Application:Part #: 361845341BCL
Back Quarter Windows Non Pop-Out Seals, Cal Look, Set of 2
Application:Part #: 2847100SS
Safaris let those warm, palmy breezes blow through your bus.
Application:Part #: 1511301E
Rear Sway Bar kit
Application:Part #: 111863149
Carpet Nails (Pack of 10) Also used for Body to Pan Seal
Application:Part #: 211405371A
These joints are located in the ends of the control arms.
Application:Part #: 6857634
Clamp on Billet Grab Handle for 1 1/2" Tubing, Angled Mount
Application:Part #: 1601120
These protect your mags from theft.
Application:Part #: 211415701D
This rod goes between the steering box and the center pin.
Application:Part #: 113863011
These are the interior panels.
Application:Part #: 151701061B
Floor Plate, Left, Convertible only
Application:Part #: 133807225
This is the strip of rubber that goes on the center of the bumper..
Application:Part #: 181955425
We carry Bosch blades for Bugs 1965 on.
Application:Part #: 1857103
This durable, plastic box replaces the stock cardboard glovebox.
Application:Part #: 1601067A
Empi Torque Star, Anthracite Black, 5x205, 5.5"x15"
Application:
This pin is a must because it holds the axle nut on.
