Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:These are the metal brake lines found throughout the car.
These are the metal brake lines found throughout the car. We suggest you go buy a 11mm tubing wrench and a tubing bender before you start replacing lines. If you have an extra 11mm box end wrench, you can cut a slot in the box end which will allow you to slip it over the tube. When breaking the metal line loose from the brake hose, use a 17mm wrench on the hose and the 11mm wrench on the metal line. Once you have broken it free, remove the clip that holds the hose. When installing the new line, hand thread the nut into the brake hose and then install the clip and tighten. You will need to take out the driver's seat when replacing the front to rear line because it runs along the tunnel. Cut the old line in half. Unthread both ends, one at the master cylinder and the one at the rear union. Pull it out from the inside of the car. Now make the bends in the new line with the tubing bender using the old line as a pattern. Install the new line from the inside of the car starting with the front. Make sure you have grommets where the line goes through the firewalls. 560mm/22"
No customer reviews for the moment.
Part #: 144863703
This is a full carpet kit.
Application:Part #: 113721163
This spring returns the brake pedal, it is very important.
Application:Part #: 181501263
These stub axles will convert your CV joints to Bus or 930 joints.
Application:Part #: 131601154
Beauty rings fit under the hubcap to improve the look of your stock rim.
Application:Part #: 6115349
If you built your motor out of a type 3 case, you probably notice that once you got it all together you're missing a dipstick tube.
Application:Part #: 111837215A
This is the return spring in the early Bug front door handles.
Application:Part #: N113672X
License Lens Screw
Application:Part #: 1415802B
This is a great way to dress up the front end of your car.
Application:Part #: 111127541A
6mm Fuel Line Union Nut
Application:Part #: 211845101A
Sky Light Roof Glass
Application:Part #: 113501753
Z-Bar Guide, Operating Arm, each
Application:Part #: N171211
These are some of the fuses and bulbs that you might need.
Application:Part #: N111571
Valve Adjusting Nut 10mm
Application:Part #: 211837205F/G
Outer Front Door Handle Pair
Application:Part #: 141943191
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 211953513D
This switch tells the flasher which way to send the current.
Application: