Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:These are the metal brake lines found throughout the car.
These are the metal brake lines found throughout the car. We suggest you go buy a 11mm tubing wrench and a tubing bender before you start replacing lines. If you have an extra 11mm box end wrench, you can cut a slot in the box end which will allow you to slip it over the tube. When breaking the metal line loose from the brake hose, use a 17mm wrench on the hose and the 11mm wrench on the metal line. Once you have broken it free, remove the clip that holds the hose. When installing the new line, hand thread the nut into the brake hose and then install the clip and tighten. You will need to take out the driver's seat when replacing the front to rear line because it runs along the tunnel. Cut the old line in half. Unthread both ends, one at the master cylinder and the one at the rear union. Pull it out from the inside of the car. Now make the bends in the new line with the tubing bender using the old line as a pattern. Install the new line from the inside of the car starting with the front. Make sure you have grommets where the line goes through the firewalls. 437mm/17.2"
No customer reviews for the moment.
Part #: 11110510110
These are used cranks with reground rod and main journals.
Application:Part #: 111837625B
Vent wing seals on the front doors keep out the elements.
Application:Part #: 211798003C
Rear Bumper Bolt Kit
Application:Bus (Type 2); 73-79
Part #: 141564914SR
These slick steering wheels have black hand-stitched, leather-grained vinyl grips with black or silver anodized aluminum spokes with machined racing holes..
Application:Part #: 1105261
Adjustable Timing Pointer
Application:Part #: N109800
Lower Channel Screws, Secures Lower to Window Frame, does Both Sides
Application:Part #: 113127511A
Fuel Line, Metal, 6mm Pump to Carburetor
Application:Part #: 133407183
To check yours remove the front wheels.
Application:Part #: 311945223B
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 113947565A
This is the switch in the door jam that turns the dome light on.
Application:Part #: 1415667
This steering wheel is a very cheap steering wheel in comparison to the Leccara wheels.
Application:Part #: 113863700
These rubber mats go on the front and rear floors.
Application:Part #: 211255719G
Heater Tube Insulating Cover, Pipe to Heater Box
Application:Part #: 113819723
Defrost Hose
Application:Part #: 1831052
These trim covers are for the interior of your car where your feet are likely to hit.
Application:Part #: 1615106B
Replacement Rear Brake Rotor Blank for 1615116A
Application: