Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:These are the metal brake lines found throughout the car.
These are the metal brake lines found throughout the car. We suggest you go buy a 11mm tubing wrench and a tubing bender before you start replacing lines. If you have an extra 11mm box end wrench, you can cut a slot in the box end which will allow you to slip it over the tube. When breaking the metal line loose from the brake hose, use a 17mm wrench on the hose and the 11mm wrench on the metal line. Once you have broken it free, remove the clip that holds the hose. When installing the new line, hand thread the nut into the brake hose and then install the clip and tighten. You will need to take out the driver's seat when replacing the front to rear line because it runs along the tunnel. Cut the old line in half. Unthread both ends, one at the master cylinder and the one at the rear union. Pull it out from the inside of the car. Now make the bends in the new line with the tubing bender using the old line as a pattern. Install the new line from the inside of the car starting with the front. Make sure you have grommets where the line goes through the firewalls. 325mm/12.8"
No customer reviews for the moment.
Part #: 1853602
These aftermarket scripts easily attach to your hood or anywhere else you choose to put them..
Application:Part #: 1070274HDW
Replacement Hardware Kit for Roof Rack #1070274K
Application:Part #: 62010718000000
Spun aluminum gas tanks for Buggies, come with either end fill or center fill option.
Application:Part #: 1129600
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 113201557E
Gas cap gasket
Application:Part #: 141945227C
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 211971028JC
Complete Wiring Harness
Application:Part #: 111857517C
These mirrors mount on the doors or door hinges so you can see what's behind you.
Application:Part #: 113201075AB
These are new Brazilian tanks.
Application:Part #: T1301101
Pinion Nut Socket
Application:Part #: 111863149
Carpet Nails (Pack of 10) Also used for Body to Pan Seal
Application:Part #: 113611021CGR
Brake Master Cylinder
Application:Part #: F1102
These are the glues and oils we use..
Application:Part #: 321971840
These are the rest of the little parts for the wiper shafts or wiper related parts..
Application:Part #: 111115175
Oil Screen 25HP engines thru 1 677 687
Application:Part #: 211801505D
Inner Front Wheel Housing Panel, Left
Application: