Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This hydraulic cylinder feeds all the wheel cylinders.
This hydraulic cylinder feeds all the wheel cylinders. After installing a new one make sure the rod that pushes the plunger is adjusted correctly. When adjusting it you can't see the measurement but you can feel it. The rod should have about an 1/8" of free play before it starts pushing. If it's too tight it will not allow the fluid to travel back to the reservoir locking up the brakes usually in the middle of an intersection.
No customer reviews for the moment.
Part #: 131721349
This adjustment nut goes on the end of the cable, back by the transmission.
Application:Part #: 112863401
These carpet kits are to be used with the original rubber floor mats.
Application:Part #: 1198161A
These rings are cast iron.
Application:Part #: 311501191REP
Rear snubber repair stud
Application:Part #: 151871042C
This boot keeps the wind from ripping up your top when it is down.
Application:Part #: 6611797
Universal Bleeder Valve, 1/8" NPT, Pair
Application:Part #: 1837581
These window cranks and door handles are made of aluminum.
Application:Part #: 1405129B
These seals are far better than the stock arm seals.
Application:Part #: 113129415B
Here are some of the replacement parts for your stock carburetor. Sold individually. No. 70
Application:Part #: 1601063CAP
Replacement Center Cap for EMPI 4 Spoke Rims
Application:Part #: 111707197A
These grommets go on the fenders or the body where the bumper brackets go through..
Application:Part #: 1107094F
94mm Wiseco Pistons-- Flat Top
Application:Part #: 1721362
Bolt-on Bowden Bracket, Zinc, Swing Axle + IRS
Application:Part #: 311105431A
Wrist Pin Bushing.
Application:Bug (Type 1); 1300-1600
Bus (Type 2); 1300-1600
Type 3; 1300-1600
KG; 1300-1600
Thing: 1300-1600
Offroad/Race; 1300-1600
Part #: 1805053
This tray mounts behind the rear seat.
Application:Part #: 113798900
Stock Replacement Pedal Assembly
Application: