Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:The rear wheel attaches to the rear brake drum.
The rear wheel attaches to the rear brake drum. Make sure you torque the axle nut to 250 ft. lb., we don't want any wheels falling off. We suggest you drive the Bug for a day and tighten the nut again. For some reason the nut seems to loosen up the first time. Always use a cotter pin to lock the nut. If the hole doesn't line up, tighten it a little bit more until it does. Never, ever back the nut off to line up the hole.
No customer reviews for the moment.
Part #: 211609209
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 113609205A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 131609209
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 211611483
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 113698261A
This kit is for rebuilding the wheel cylinder.
Application:Part #: 113611053B
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 113698003
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 113609537C
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 113609439E
Brake Backing Plate, Left Rear
Application:Part #: 113609440E
Brake Backing Plate, Right Rear
Application:Part #: 1198092B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 112950502IDA
Stack Hold Down Screw and Washer
Application:Part #: 1101374
40 HP Barrel Shims .040 (4)
Application:Part #: 113867503
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 211863615
Door Panel Screw and Washer Set
Application:Part #: 111411155
Nut for Grub Screw for Torsion Bar
Application:Part #: 111201551
Gas Cap, 100mm with Gasket
Application:Part #: 241707420
Bumper Rubber Insert for Deluxe Bus Bumpers
Application:Part #: T1301142
This is a "must" for your tool box.
Application:Part #: 6601015WH
These are the most popular off road wheels.
Application:Part #: 133863507
Front Trunk Liner Upper
Application:Part #: 3251005
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 143845321C
Pop-Out Quarter Window Seal, fits both sides (Each)
Application:Part #: 211609701H
These cables set the rear brakes.
Application:Part #: 113867507
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 111501131
This kit contains all of the gaskets needed to rebuild a transmission.
Application: