Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:The rear wheel attaches to the rear brake drum.
The rear wheel attaches to the rear brake drum. Make sure you torque the axle nut to 250 ft. lb., we don't want any wheels falling off. We suggest you drive the Bug for a day and tighten the nut again. For some reason the nut seems to loosen up the first time. Always use a cotter pin to lock the nut. If the hole doesn't line up, tighten it a little bit more until it does. Never, ever back the nut off to line up the hole.
Bus (Type 2): 71-79
No customer reviews for the moment.
Part #: 113609205A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 211609209A
These are the screws and adjusting stars that freeze up and keep you from adjusting your brakes.
Application:Part #: 211611477A
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 211611483
This valve in the wheel cylinder allows you to bleed the brakes.
Application:Part #: 211698301
This kit is for rebuilding the wheel cylinder.
Application:Part #: 211698291
This kit is for rebuilding the wheel cylinder.
Application:Part #: 211611047F
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 211611047C
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 113609163
You will find this little plug in the backside of the rear backing plates on cars 1968 and later.
Application:Part #: 211698003A
This kit has all the springs, pins and keepers for drum brakes.
Application:Part #: 211609537J
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 211609537N
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 211609537K
These shoes or linings are in the rear drums and are new, so no exchange.
Application:Part #: 211611047FGR
Rear Wheel Brake Cylinder, GERMAN
Application:Part #: 6801121
These tabs are used for mounting just about anything to tubing..
Application:Part #: 111813151B
Rear Lower Firewall, Left
Application:Part #: 111127591A
Fuel Line Grommet 8mm
Application:Part #: 261827711C
It seals the engine lid to keep the air that is forced through the side vents from being sucked out the back and making it go through the fan where it is most needed..
Application:Part #: 1127026H
Fuel Pressure Regulator, Tumble Polished Finish, 1-4 PSI
Application:Part #: 6501201
15 5/8" Axles for Type 2 trans with Type 1 and 2 Joints
Application:Part #: 255837625A
Vent Wing Window Seal, GERMAN, Left
Application:Part #: AL25XCO
Alternator For Diesel Applications Core
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 111201635A
Fuel Tank Clamp Plate
Application:Part #: 1821306ASS
These were originally sold as an accessory by the dealer.
Application:Part #: 1101440
This is a shim that is used between the head and barrel.
Application:Part #: 113941541IV
These are the knobs for the wiper and light switches on the dash.
Application:Part #: 025101065C
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 211609701F
These cables set the rear brakes.
Application:Part #: 113301155
This is the bushing between the bellhousing of the transmission and the starter.
Application: