Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:This is the front brake rotor that the pads ride against on the disc brake front ends.
This is the front brake rotor that the pads ride against on the disc brake front ends. Note: When tightening the bearing nut, snug it down against the bearing thrust washer. Now line up the handle of your wrench with one of the lug bolts and back the nut off so the handle of the wrench lines up with the next bolt (a fifth of a turn). Those useing four lug rotors back off just before the next lug bolt. This will prevent bearings from heating up and wearing out.
Bus (Type 2): 73-79
No customer reviews for the moment.
Part #: 211615107A
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle. If you are ordering this without sending your core in first you will need to order the core as well. The core charge will be refunded when we get your core back and it is rebuildable.
Application:Part #: 211615108A
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle. If you are ordering this without sending your core in first you will need to order the core as well. The core charge will be refunded when we get your core back and it is rebuildable.
Application:Part #: 135998162
The wiper arms are connected to these shafts.
Application:Part #: 211721613
Accelerator Pedal Bracket, welds to floor
Application:Part #: 1615117IRS
Rear Disc Brake Kit With E Brake, Blank (undrilled) Rotors, IRS, HD Brackets 1968-72
Application:Part #: N185161
These fittings fit on the front end so you can pump grease in the front suspension..
Application:Part #: 2847101SS
This makes the rear window pop out like the front windows.
Application:Part #: 111405129
These seals go around the arms to keep the dirt out of the front beam.
Application:Part #: 251405645B
These bearings go in the drum or rotor hub to allow them to spin.
Application:Part #: 1601063B
Empi 4 Spoke, Matte Black, 4x130, 15x5.5"
Application:Part #: 111883410
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: 1127109
This is a brass tee for dual carbs.
Application:Part #: 113953161B
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: 111105287
Flywheel Shim 25-36HP, .34mm (0.0135")
Application:Part #: 111881404
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: 6415812B
Tapered Chromoly Bung, mainly used for fabricating Tie Rods on Offroad/Race Applications. Thread 3/4"-16 RH
Application:Part #: 6881400BKGY
These are the real deal.
Application: