Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This valve in the wheel cylinder allows you to bleed the brakes.
This valve in the wheel cylinder allows you to bleed the brakes. If the bleeder valve has broken off, we've found it's easier to replace the whole wheel cylinder because you usually ruin the cylinder before you get the valve out. A slick trick with these as well is to place them on your grease zerts to keep the dirt out.
No customer reviews for the moment.
Part #: 1129517
Linkage Ball End Bushings, Pair
Application:Part #: 113198700
Dual Port Manifold End Castings - Pair
Application:Part #: 1615108
This kit allows you to run disc brakes in the rear.
Application:Part #: 111971019
The electrical harness runs everything on the car. This is just the Main harness that goes front to rear. Does NOT have any of the front wires in it.
Application:Part #: 361611067AGR
This hydraulic slave cylinder is found in the front brake backing plate. GERMAN
Application:Part #: 111941191Q
This seal goes in the headlight buckets.
Application:Part #: 211251051E
This is the exhaust silencer.
Application:Part #: 311853321
The front door window rolls up and down between these two rubber seals.
Application:Part #: 2501102CO
CORE CHARGE
Application:Part #: 111899123A
This is a little rubber pad that goes on the front beam where you attach the beam to the body.
Application:Part #: 1129511A
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 211945245
This seal goes between the tail light housing and the body of the car..
Application:Part #: 211801051D
This area tends to rust.
Application:Part #: 6415066
Rack and Pinion Unit, 2 mounting holes, 11 5/8", 36 Spline Shaft, 1.5 turns lock to lock
Application:Part #: 1601060APL
Empi 5-Rib 5x205, 5.5"x15"
Application: