Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Filter By
Color
Color
Price
Price
$1.00 - $765.00
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:There are 52 products.
Part #: 241898001
These polished replacement kits are designed to fit the original contour molding profile.
Application:Part #: 241898002
These polished replacement kits are designed to fit the original contour molding profile.
Application:Part #: 241853579K
Body Molding End Cap Kit, finishes the ends of the early Deluxe Bus Body Molding, 14 piece kit
Application:Part #: 241853579
Body Molding End Cap
Application:Part #: 241853571
This molding was originally equipped on deluxe buses on the lower rocker panels.
Application:Part #: 211819165
Air Intake Screen, Plastic
Application:Part #: 241853547
These are the clips that hold the various chrome moldings on.
Application:Part #: 281843799
This beading goes betwen the body and the rail cover that hides the arm for the sliding door.
Application:Part #: N120801
These are four little plastic pieces that push into the front hood to hold the emblem in place.
Application:Part #: 211857611A
Front Emblem Seals
Application:Part #: 211853615
These are three little plastic pieces that push into the front hood to hold the emblem in place.
Application:Part #: 211853619
These are three little plastic pieces that push into the front hood to hold the emblem in place.
Application: