Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:Body Molding End Cap
Body Molding End Cap, finishes the ends of the Early Deluxe bus body molding (14 per bus)
Bus (Type 2): -67
No customer reviews for the moment.
Part #: 141837475C
Outside Scraper, Rubber Only
Application:Part #: 1070274LK
This rack fits on the roof of your bug and clamps down in the rain gutter.
Application:Part #: 1115109
This oil thermostat goes in line on your external oil cooler system.
Application:Part #: 211919033
Fuel Gauge, 12 volt, bulb and holder sold separately
Application:Part #: 211199231CGR
They mount on the crossbar of 68 and later Buses.
Application:Part #: 6105256BK
Sand Seal Pulley Kit, Includes Aluminum Collar and Orange Seal
Application:Part #: 111831721
Door to Body Seal, Set of 2
Application:Part #: 1827026
These are the aluminum trim pieces that go over the deck lid louvers..
Application:Part #: 6801240
Universal Billet Support Bracket, 1 1/2" clamps, measures 4 7/16"L x 3"H x 2 1/2"W
Application:Part #: 2805001
This mounts the tire onto the front of the bus getting it out of the interior.
Application:Part #: 113105701
These are the shells that go in the rods and ride on the crank.
Application:Part #: N154011
These nuts and washers hold the heads on.
Application:Part #: 6881410ARD
These seats are better than the fiberglass, but still no where near as good as beard seats.
Application:Part #: 1198578
This kit has the gaskets, o-rings, accelerator pump and needle and seat to rebuild an IDF carb.
Application:Part #: 211813163N
This is what the battery sits on.
Application: