Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
-Written by Steve Phillips for HotVWs Magazine- Building a Daily Driver - Part 2 The size of the motor is the bore and stroke. So what is a good size to have? Let’s talk about the two.
I have been getting asked alot what is a good engine combo for a daily driver. This is such a loaded question and everybody has their opinion on this subject. So I am going to explain how I pick out a motor combo and why.
Trying to decide between points or an electronic ignition? Let’s go look at both.
- Written by Steve Phillips for Hot VWs Magazine- We all know what a stock size pulley is, but does everyone know what a power pulley is? And if it actually gives you more power? How does a pulley do that? It's not driving a supercharger, so how does it work?
- Written by Steve Phillips for HotVWs Magazine - We got a lot of rain this winter, followed by a lot of sun and heat, so in this article I am going to tell you how to replace your windshield seal (works on any stationary seal).
- Written by Steve Phillips for HotVWs Magazine - What does Full Flowing a case mean? Well what it refers to is drilling and tapping one of the oil galleys on the engine case for a return line.
Out with the old, in with the new…..er Our old faithful Punch Press, lovingly referred to as Old Punchy, finally gets to retire at the hand of some (slightly) newer equipment.
-Written by Steve Phillips for HotVWs Magazine- To paint a case or not to paint a case? I am seeing a lot of cases coming in our shop that are painted. Is this good or bad?
In case you missed it, here's a little recap from our 5th Annual Show & Shine on April 28th!
- Written by Steve Phillips for HotVWs Magazine - Last month we talked about pressure plates so I think it's only fitting to talk about the throw out bearing arm. Here I’m going to walk you through some common issues, and what to look for when replacing them.
- Written By Steve Phillips for HotVWs Magazine - Let’s talk about pressure plates; there are all kinds out there. In this article I would like to describe the different types, and styles.
- Written by Steve Phillips for HotVWs Magazine - What mounts should you run? There are a few different choices here. You have stock crap, you have stock Brazilian which are ok, you have urethane, and you have solid. In this article, I will go through the pros and cons of each.
