Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the metal brake lines found throughout the car.
These are the metal brake lines found throughout the car. We suggest you go buy a 11mm tubing wrench and a tubing bender before you start replacing lines. If you have an extra 11mm box end wrench, you can cut a slot in the box end which will allow you to slip it over the tube. When breaking the metal line loose from the brake hose, use a 17mm wrench on the hose and the 11mm wrench on the metal line. Once you have broken it free, remove the clip that holds the hose. When installing the new line, hand thread the nut into the brake hose and then install the clip and tighten. You will need to take out the driver's seat when replacing the front to rear line because it runs along the tunnel. Cut the old line in half. Unthread both ends, one at the master cylinder and the one at the rear union. Pull it out from the inside of the car. Now make the bends in the new line with the tubing bender using the old line as a pattern. Install the new line from the inside of the car starting with the front. Make sure you have grommets where the line goes through the firewalls. 720mm/28.3"
No customer reviews for the moment.
Part #: 211863112
These are the interior panels.
Application:Part #: 1711301
This aluminum cover slips over your stock emergency brake handle for a customized look..
Application:Part #: 1615113
Deluxe Zero Off-set 5x205 Rear Disc Brake Kit with E-Brake, 1968 IRS and Swing Axles, Cast Brackets
Application:Part #: 311141031B
This disc transfers the power from the motor to the transmission.
Application:Part #: 2847104WH
This makes the rear window pop out like the front windows.
Application:Part #: 281843336A
Side sliding door hinge
Application:Bus (Type 2); 68-79
Part #: 2405645
This kit allows you way to bolt on disc brakes to the front of your king and link pin front end.
Application:Part #: 111255415F
Bakelite Heater Tube, Left
Application:Part #: 211837605D
Complete Vent Window Assembly, Left
Application:Part #: 111943191
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 6801199
Threaded bung, 3/4"-16 RH, 1"x.120, 2 3/8" Long
Application:Part #: 264809041DX
Left Side Panel with Compartment on Left Hand Side Single Cab Only
Application:Part #: 1598021BL
These boots are great for your swing axle because they last longer than stock boots.
Application:Part #: 261801475
Pickup Front Bed Section 45"x36"
Application:Part #: 6513028
This boss comes in real handy when making upper shock mounts or putting on rear lower shock mounts in IRS cars..
Application:
These are the metal brake lines found throughout the car.