Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the metal brake lines found throughout the car.
These are the metal brake lines found throughout the car. We suggest you go buy a 11mm tubing wrench and a tubing bender before you start replacing lines. If you have an extra 11mm box end wrench, you can cut a slot in the box end which will allow you to slip it over the tube. When breaking the metal line loose from the brake hose, use a 17mm wrench on the hose and the 11mm wrench on the metal line. Once you have broken it free, remove the clip that holds the hose. When installing the new line, hand thread the nut into the brake hose and then install the clip and tighten. You will need to take out the driver's seat when replacing the front to rear line because it runs along the tunnel. Cut the old line in half. Unthread both ends, one at the master cylinder and the one at the rear union. Pull it out from the inside of the car. Now make the bends in the new line with the tubing bender using the old line as a pattern. Install the new line from the inside of the car starting with the front. Make sure you have grommets where the line goes through the firewalls.
Bug (Type 1): SB,71-79
No customer reviews for the moment.
Part #: 211711630C
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: N177321
These are some of the fuses and bulbs that you might need.
Application:Part #: 251837187A
These little knobs and collars go on the two front doors.
Application:Part #: 211847439A
This seal is for factory safaris only.
Application:Part #: 111805501C
This clip goes back to the gas tank area.
Application:Part #: 211611703
Front brake hose
Application:Part #: 311501581
The rear wheel attaches to the rear brake drum.
Application:Part #: 112950505IDF
Throttle Shaft Lock Tab Washer for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 2847104WH
This makes the rear window pop out like the front windows.
Application:Part #: 6251003IN
A stinger (depending on your motor combo) makes horsepower at 5K RPM and above.
Application:Part #: 68012004
Set of 4 Universal Mounting Tabs with 1/2" hole
Application:Part #: 1827331
This extension allows you to run the deck lid spring when using the deck lid stand offs..
Application:Part #: 133945224A
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 6857700
It's the law and besides you really do want a good set of seat belts if you going to be out playing..
Application:Part #: 1601133BLK
Porsche Style Lug Nuts, 14mm-1.5, Black, Set of 5
Application:
These are the metal brake lines found throughout the car.