Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:These panels go in the dash so you can install gauges.
These panels go in the dash so you can install gauges. You'll have to trim some metal behind the panel in order to put your gauges in. Holes are 2 1/16"
No customer reviews for the moment.
Part #: 111903221A
These are the bearings and brushes for your generator.
Application:Part #: 141857551AWH
These are the visors you pull down to keep the sun out of your eyes.
Application:Part #: 141953161AAM
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: 133823731B
This is the seal that goes on the body for the front hood to sit on.
Application:Part #: 111805501B
This clip goes back to the gas tank area.
Application:Part #: 1198578
This kit has the gaskets, o-rings, accelerator pump and needle and seat to rebuild an IDF carb.
Application:Part #: 111511255C
Spring Plate Covers, Pair
Application:Part #: 1119317CH
Cool tins are must for those of you with high performance exhaust systems without heater boxes.
Application:Part #: 111941119
This seal goes in the headlight buckets.
Application:Part #: 10x875
Fan Belt 10x875 for Racing Applications Only
Application:Part #: 111937391
If you don't have one get one.
Application:Part #: 6823564
There are two types of hold downs, rubber and steel.
Application:Part #: 211707291
This is the rubber pads that are on the ends of the front bumper on a 1968-1972 Bus..
Application:Part #: 1255105FCC
HD Flanged 1 1/2" heater boxes to run with your performance Engine & Exhaust, Left
Application:Part #: 111141031E
This disc transfers the power from the motor to the transmission.
Application: