Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bus (Type 2): 68-79
Type 3: 68-73
No customer reviews for the moment.
Part #: 1129516
Empi Hex Bar Linkage Bearing Conversion Kit
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 151845121BAM
This seal goes around the front window.
Application:Part #: T1101025
If you're like us and have a few motors laying around, these dollies come in real handy when you have to move them around.
Application:Part #: T1301142
This is a "must" for your tool box.
Application:Part #: 6401234
These go from the front beam to the belly pan to strengthen the front beam area.
Application:Part #: 241853579K
Body Molding End Cap Kit, finishes the ends of the early Deluxe Bus Body Molding, 14 piece kit
Application:Part #: 1117323
Hoover Bit
Application:Bug (Type 1); 1600
Bus (Type 2); 1600
KG; 1600
Thing; 1600
Offroad/race car; 1600
Part #: 211809506B
The lower part of the dog leg.
Application:Part #: T1198088
This cheap tool allows you to get the cylinder barrels over the pistons and rings.
Application:Part #: 1198026
This kit contains a quality brass bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:Part #: 021105401RC
Re-conditioned Piston Rods for 1700-1800cc engines.
Application:Part #: 6501281
Billet Aluminum Bearing Cap, Each
Application:Part #: 6885400
Rear Fiberglass Buggy Seat 34 1/4"
Application:Part #: 1129304040
These are some of the most common jets used. Sold individually.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
