Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the mechanism that makes the window go up and down.
This is the mechanism that makes the window go up and down. Getting the mechanism out is a pain. You will have to start by taking the door panel off and then disconnect the glass from the regulator. Now you're ready for the tough part. The vent wing post has to come loose so look for a bolt holding it to the inner skin of the door. Pay attention to how the regulator is installed in this area, as you will want to put it back the same way. Note: We lay the regulator down flat before installing, squirt some Triflow on the cable and then roll it up and down a few times. This will help the regulator last longer.
Bug (Type 1): 68-74
Off-Road: 68-74
No customer reviews for the moment.
Part #: 1129201301
48mm/51mm IDA Carb Float Only
Application:Part #: 1881404CU
Like the custom door panels these car seat covers are a great way to customize the interior of your Bug.
Application:Part #: 311141025C
The clutch cover is also known as a pressure plate.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 211817539
Inner Roof Strength Panel 2.5 Meters (98")
Application:Part #: 211611724C
These are the metal brake lines found throughout the car.
Application:Part #: 113141701C
This shaft holds the throw-out bearing in place.
Application:Part #: 251407691A
Left Front bearing cap
Application:Part #: 151857611A
This is a strap, not a handle.
Application:Part #: 1881050
We really like the style and comfort that these seats provide.
Application:Part #: 113953051K
Turn Signal Bulb Holder, Each
Application:Part #: 133133511
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: 211843436B
Side Sliding Door Upper Roller and Bracket
Application:Bus (Type 2); 68-79
Part #: JC44500
Jaycee Shorty Billet IDA Stacks, Red, Each
Application:Part #: 1198090B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 111813301J
The rear apron is the panel between the rear fenders.
Application:
This is the mechanism that makes the window go up and down.
