Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Middle Seat Floor Mount Reinforcement Plate, Welds onto floor and supplies support for mount
Middle Seat Floor Mount Reinforcement Plate, Welds onto floor and supplies support for mount
Bus (Type 2): 55-67
No customer reviews for the moment.
Part #: 113857113
Clip for Ash Tray, 2 Required
Application:Part #: 62010718E5
End Fill 8x24" Polished Stainless Steel Gas Tank
Application:Part #: 113721001
Pedal Assembly Bushing Kit
Application:Part #: 6105248
Replacement Seal and Collar for Bolt-in Sand Seal
Application:Part #: 111831721DBR
Front door seals keep out the wind, rain, dirt and noise.
Application:Part #: 113819717B
Heater hose (Pair) connects fresh air box to side pieces
Application:Part #: 1129028
Replacement Tubes & Brackets only for Empi EPC 32/36F carbs
Application:Part #: 151847322A
Quarter Window Hinge, Right, Convertibles only Bug (Type 1): 65-79
Application:Part #: 1117102
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 141871031
This is the outer skin on your convertible.
Application:Part #: 211837605
Vent Window Assembly, Left
Application:Part #: 6301150A
Type 2 Transmission Center Mount Only
Application:Part #: 1707135BCH
This is one of the original bumper options that was used on the first Cal-Look Bugs back in the 70's.
Application:Part #: 211898000
Bus Ignition, 2 front locking door handles and rear hatch handle all keyed alike, only 2 keys included!
Application:Part #: 1601070
EMPI Smoothie Polished, 4x130, 5.5"x15"
Application:Part #: 147251157
This is also a form of muffler that goes on the exit port of the stock main muffler.
Application:
Middle Seat Floor Mount Reinforcement Plate, Welds onto floor and supplies support for mount