Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are two of the different types of exhaust nuts.
These are two of the different types of exhaust nuts. If you are running a larger tubing size on your exhaust, then we suggest using the 12mm or the 11mm nuts. The copper ones don't back off, but we find when you want to take them off, they tend to pull the stud so we like the steel ones better.
No customer reviews for the moment.
Part #: 1251166
This is a reproduction of an accesory that was offered by the dealer.
Application:Part #: 1251005
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251201
When you upgrade to dual carburetors, use these plates to block off the heat risers on your headers or stock exhaust system.
Application:Part #: 1256092
Also called J-tubes, these tubes fit most header systems and replace the stock heater boxes, so you will lose your heat and defroster..
Application:Part #: 111251261B
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 1251161
A stinger (depending on your motor combo) makes horsepower at 5K RPM and above.
Application:Part #: 1251006
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251202
This is the 3-bolt gasket that goes between the muffler and the header.
Application:Part #: 1251261
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 1251262C
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 125121112
Exhaust nuts 12 Point 8mm-1.25, use 10mm 12 point socket (8 per kit)
Application:Part #: 1251210S
6 Point 8mm-1.25 thread Engine Nuts, Uses 10mm Wrench
Application:Part #: 1251211
These are two of the different types of exhaust nuts.
Application:Part #: 1251009SS
EMPI Stainless Steel PHAT Boy Muffler
Application:Part #: 1251163
These fit all stock mufflers and come in three different styles..
Application:Part #: 1251005LF
Large 3 bolt flange Single Quiet pack Muffler
Application:
These are two of the different types of exhaust nuts.
