Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the 3-bolt gasket that goes between the muffler and the header. Hint: The bolts tend to come loose after they heat up the first time. Therefore, after you replace the gasket, drive the car for a day and tighten the bolts again.
Bug (Type 1): All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1251010CC
Hide Out Muffler Ceramic Coated
Application:Part #: 1251000CC
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251005MRG
Dual Quiet Muffler for Merged Header
Application:Part #: 1251200
This kit comes with four flanges, two for the heater boxes and two for the header. Sold EACH, 2 required.
Application:Part #: 1251010M
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1251199
This is the 3-bolt gasket that goes between the muffler and the header.
Application:Part #: 1251261C
Paper gaskets are not our favorite, but if you are running larger ports, you have to use them.
Application:Part #: 1256092
Also called J-tubes, these tubes fit most header systems and replace the stock heater boxes, so you will lose your heat and defroster..
Application:Part #: 1251263
A stinger (depending on your motor combo) makes horsepower at 5K RPM and above.
Application:Part #: 1251009CC
EMPI Ceramic Coated PHAT Boy Muffler
Application:Part #: 1251201CH
Chrome Heat Riser Block-Off Plate Kit
Application:Part #: 1251202
This is the 3-bolt gasket that goes between the muffler and the header.
Application:Part #: 1251210S
6 Point 8mm-1.25 thread Engine Nuts, Uses 10mm Wrench
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1251014SS
Stainless Steel Phat Boy Muffler for Merged Exhaust
Application:Part #: 1251008H
1 5/8" Merged Flanged Header with Stinger (No Heater Boxes Included)
Application:
