Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These grommets go on the spring plates in the torsion housing of your car.
These grommets go on the spring plates in the torsion housing of your car. They don't flex like the original stock rubber ones and unfortunately they transmit a lot of noise into the car. Sold in pairs.
Race/Off-Road: All
No customer reviews for the moment.
Part #: 6501201
15 5/8" Axles for Type 2 trans with Type 1 and 2 Joints
Application:Part #: 6501205SW
These plates are .250" thick, that means they can handle the abuse of off roading.
Application:Part #: 1511223
Polished Stainless Steel Torsion End Plate, IRS, Pair
Application:Part #: 6501205IRS
These plates are .250" thick, that means they can handle the abuse of off roading.
Application:Part #: 6501229
These are hardened aircraft quality CV joint bolts.
Application:Part #: 1598021BL
These boots are great for your swing axle because they last longer than stock boots.
Application:Part #: 6501149100B
These boots and flanges are designed for axles with very long suspension travel.
Application:Part #: 1511242
These grommets go on the spring plates in the torsion housing of your car.
Application:Part #: 2517289
These seals fit into the CV joint flange to keep the axle from beating the transmission cup and to keep the transmission oil out of the CV joint.
Application:Part #: 1511227
This cap goes over the torsion bar end of the spring plate holding the grommet.
Application:Part #: 1598021BK
These boots are great for your swing axle because they last longer than stock boots.
Application:Part #: 1501581
Chromoloy Rear Hub 5/130mm for Short Axle (each)
Application:Part #: 6501243
These spacers for the IRS stub axles are much stronger than the stock.
Application:Part #: 6501331W
CV Boot Torque Plate (3 per Boot) for 930
Application:Part #: 6501280
Steel Axle Bearing Housing
Application:Part #: 6501149108FB
Billet Boot Retainer and CV Flange, Set (Boot not included)
Application:
These grommets go on the spring plates in the torsion housing of your car.
