Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:These boots are made to keep water and dirt out of distributor and coil.
These boots are made to keep water and dirt out of distributor and coil. They're a real pain to put on.
Race/Off-Road: All
No customer reviews for the moment.
Part #: 01009
These are the parts found in the distributor.
Application:Part #: 113905451
These plastic plugs go into the fan shroud to hold the spark plug wires off the block and heat risers.
Application:Part #: 1905115
This chrome cover and bracket goes over a coil to dress it up.
Application:Part #: 113905451A
Ignition Cable Holder
Application:Part #: 02086
These are the parts found in the distributor.
Application:Part #: 6905811
If you want a keyed ignition switch for you buggy or tube car, here you go.
Application:Part #: 03010
These are the parts found in the distributor.
Application:Part #: 1905250
This chrome clamp holds the distributor in time, as well as holding it onto the case.
Application:Part #: 03037
These are the parts found in the distributor.
Application:Part #: NGK D9EA
This Spark plug is only used for Racing or Competition vehicles due to the size of the Spark Plug; Dimensions Below Thread Pitch: 12mm x 1.25mm, Thread Length: 19mm (3/4") Verify that the Thread Pitch and length is compatible with your heads if you have any questions call and ask prior to ordering.
Application:Part #: 04004
These are the parts found in the distributor.
Application:Part #: 04008
These are the parts found in the distributor.
Application:Part #: 6B03010WH
These boots are made to keep water and dirt out of distributor and coil.
Application:Part #: 1B03010BL
These caps look cool and come in different colors, but that's the only good thing we can say about them.
Application:Part #: 04038
These are the parts found in the distributor.
Application:Part #: NGK B6HS
When replacing these use anti-seize on the threads. NGK B6HS is direct swap for this Bosch W7AC Plug
Application: