Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the metal brake lines found throughout the car.
These are the metal brake lines found throughout the car. We suggest you go buy a 11mm tubing wrench and a tubing bender before you start replacing lines. If you have an extra 11mm box end wrench, you can cut a slot in the box end which will allow you to slip it over the tube. When breaking the metal line loose from the brake hose, use a 17mm wrench on the hose and the 11mm wrench on the metal line. Once you have broken it free, remove the clip that holds the hose. When installing the new line, hand thread the nut into the brake hose and then install the clip and tighten. You will need to take out the driver's seat when replacing the front to rear line because it runs along the tunnel. Cut the old line in half. Unthread both ends, one at the master cylinder and the one at the rear union. Pull it out from the inside of the car. Now make the bends in the new line with the tubing bender using the old line as a pattern. Install the new line from the inside of the car starting with the front. Make sure you have grommets where the line goes through the firewalls.
Bus (Type 2): 67
No customer reviews for the moment.
Part #: N177251
These are some of the fuses and bulbs that you might need.
Application:Part #: 111711713A
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 1070275K
Deck Lid Rack Knock Down Style
Application:Part #: 261809252
B Post Outer Section With Right Storage Compartment 550mm (21.65")
Application:Part #: 111119141A
Cooling Fan Nut
Application:Part #: 211609701B
Emergency Brake Cable (3168mm/124.7")
Application:Part #: 113707156
Chrome Bumper Guards with Impact Strip
Application:Part #: 113853535A
This is the chrome trim that went on the front and sides of the Bug to dress it up.
Application:Part #: 151837633B
Vent wing Upper Pivot Screw, Convertible Bug (Type 1): 73-79
Application:Part #: 141561411AKT
EMPI Dark Classic Wood Steering Wheel with install kit
Application:Part #: 211813001
Rear Apron Installation Hardware Kit
Application:Part #: 211845121A
This seal goes around the front window.
Application:Part #: 2129039
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 152863404
These carpet kits are to be used with the original rubber floor mats.
Application:Part #: 1898122
These window seals don't have the groove in them for the chrome trim, giving the car the Cal Look.
Application:
These are the metal brake lines found throughout the car.