Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
A case saver is an insert that repairs worn or stripped head stud holes in a case.
A case saver is an insert that repairs worn or stripped head stud holes in a case. They prevent head studs from pulling under normal use. If you don't already have case savers, you should think about having them installed. 16 are required.
Bug (Type 1): All
Bus (Type 2): -71
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 111115421
Oil Relief Valve Spring 25-36 HP
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111199102
This nut came on all dual relief cases.
Application:Part #: 113105245FRS
Rear Main Seal, Double Lipped
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 111198007AF
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 113101157C
This plug goes in the back of the case (flywheel side).
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 040101157
This plug goes in the back of the case (flywheel side).
Application:Part #: 043101025
We only carry NEW dual relief cases. Limited supply!
Application:Part #: 1101157
This cam plug is made out of billet alluminum and has an o-ring on it.
Application:Part #: 113101221B
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: 1101211
This chrome stand dresses up your engine.
Application:
A case saver is an insert that repairs worn or stripped head stud holes in a case.
