Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These joints are located in the ends of the control arms.
These joints are located in the ends of the control arms. You will need a press and some special tools to replace the joints on a standard Bug. Note: Remove the boot before you press the joint in the arm and then put it back on after. There are four ball joints per car on a standard Bug. Super Beetle ball joints just bolt on and there is only one per side.
Thing (Type 5): 1973-74
No customer reviews for the moment.
Part #: 111821715AOE
This is the beading that goes between the fender and the body.
Application:Part #: 1941104
This little cover goes between the glass and the chrome ring on your headlight bucket making the car look like it has eyebrows.
Application:Part #: 2413002
KYB Excel-G Gas Shock, Front
Application:Part #: 1411105
This is the only correct way to lower the front end of a Super Beetle.
Application:Part #: 111837640B
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
Application:Part #: 2251205
Muffler Flange Gasket (Pair)
Application:Part #: 1109306
Chromoly Stock length Push Rods Set
Application:Part #: 113517191
Swing Axle Fulcrum Plates
Application:Part #: 043109451
This screw rides against your valve, opening and closing it.
Application:Part #: 113903141B
The generator strap goes around the generator and holds the generator to the stand..
Application:Part #: 6707103
These bumpers are made for Baja Bugs.
Application:Part #: 071256052
Heat Riser Elbow, Right
Application:Part #: 152701062B
Floor Plate, Right, Convertible
Application:Part #: 211809254
B Post Repair Section, Inner, Right, 200mm (7.9") high
Application:Part #: 1821305A
These were originally sold as an accessory by the dealer.
Application:Part #: 1101141
1/2" Longer 10mm Case Studs
Application:
These joints are located in the ends of the control arms.
