Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:Do you have a lowered beam now? They should have come with a kidney belt and a mouth guard.
Do you have a lowered beam now? They should have come with a kidney belt and a mouth guard. So, here's the answer. Put lowered spindles on your bug or bus and it will ride like it did stock. The bug spindles come with a 2 1/2" drop and the bus with a 3 1/2" drop. On the king and link bug spindles you can get spindles only or have us install the king and link pins. Those of you with 66, 67 bugs will have to change the outer tie rod end to 68 and later. On the bus spindles they only come with the king pins rebuilt. Also on the bus spindles you will need a tie rod with ends from a 1968-1979 (part number 211 415 801F). This is necessary to give more frame clearance. These spindes are cast not welded. Sold in pairs and some on an exchange basis.
Bug (Type 1): 66-
Ghia: 66-74
No customer reviews for the moment.
Part #: AL75XCO
This unit supplies the battery with voltage.
Application:Part #: 068141033J
This disc transfers the power from the motor to the transmission.
Application:Part #: 111809132G
Front Bumper Mount, Right, Standard Beetle Only
Application:Part #: 1101481
These are great valve covers gaskets.
Application:Part #: 113953051K
Turn Signal Bulb Holder, Each
Application:Part #: 211498211ACO
CORE CHARGE If you would like to order these before sending your old spindles in, please add part this to your order. This is the core charge. Once you send back your old spindles we will refund that amount, providing your spindles are good.
Application:Part #: 211255723B
Heater Tube Insulating Cover, Center Section
Application:Part #: 261813355E
Truck rear corner
Application:Part #: 211841549
Cargo Door Hinge Screw Plug, 8 per car, Sold each
Application:Part #: N142701
Outside Door Handle Screw
Application:Part #: 111837475A
The front door window rolls up and down between these two rubber seals.
Application:Part #: 111837625B
Vent wing seals on the front doors keep out the elements.
Application:Part #: 141857502A
These mirrors mount on the doors or door hinges so you can see what's behind you.
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 1615100
This kit allows you to bolt disc brakes onto your Bug king and link pin or ball joint front end.
Application:Part #: 111953161CL
These are the lenses that go over the front turn signal bulb holders.
Application: