Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Heater cables open the flaps in the heater boxes allowing heat into the car.
Heater cables open the flaps in the heater boxes allowing heat into the car. When you install the cables use white grease. Place the control(s) in the off position and crawl under the Bug and hook up the heater boxes. (A buddy sure would be helpful.) Now get back up and put the control(s) in the full on position and then crawl back under the car and push the lever on the heater box all of the way forward and lock into place. (Remember exercise is good for you.) Now recheck the levers to make sure they are closed when the control(s) are in the off position. On 1964 and earlier Bugs, the heater cable is attached to a slide. To get the slide out, twist the knob clockwise all the way. Just under the knob you will see a knurled collar. Wrap a rag around this collar and use a pair of pliers to unthread it. Once the collar is unthreaded you will be able to pull the slide out. When putting the slide back in make sure that the slot in the slide indexes itself to the spot on the slide hole.
No customer reviews for the moment.
Part #: 111945241C
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 211837235AIV
This plastic "donut" goes under the window crank or door handle to prevent the door panel from getting ripped.
Application:Part #: 6251014C
Off-Road Copetition exhaust systems with stainless steel mufflers.
Application:Part #: 111857514
These mirrors mount on the doors or door hinges so you can see what's behind you.
Application:Part #: 113837019BCH
Driver's Inside Door Handle
Application:Part #: 181405371C
These joints are located in the ends of the control arms.
Application:Part #: 1601028BCP
EMPI 8 Spoke Replacement Black Center Cap
Application:Part #: 311609632
Parking Brake Push Bar
Application:Part #: 113301229A
This is the front of the transmission that houses the shift lever.
Application:Part #: 211809258
"B" Post Outer Repair Section, Right 400mm (15.75")
Application:Part #: 1903141
This chrome strap holds the alternator or generator to the stand.
Application:Part #: 251919051E
The sending unit registers the fuel level on the gauge.
Application:Part #: 211721351A
This pin goes on the front end of the clutch cable and should be replaced when you replace the cable.
Application:
Heater cables open the flaps in the heater boxes allowing heat into the car.