Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This kit comes with everthing you need to eliminate your vent window, tempered glass, felt window channels, inner and outer snap in scrappers.
This kit comes with everthing you need to eliminate your vent window, tempered glass, felt window channels, inner and outer snap in scrappers. On bugs up to 1964 you will need the window regulators and sashes from a bug 1965-1967.
Bug (Type 1): 65-
Off-Road: 65-
No customer reviews for the moment.
Part #: 111115421
Oil Relief Valve Spring 25-36 HP
Application:Part #: 113941541BK
These are the knobs for the wiper and light switches on the dash.
Application:Part #: 365853355
Rear Window Trim, includes Clips
Application:Part #: 1129201304
Replacement Float for EMPI EPC 32/36A, E, M, EPC 38, Each
Application:Part #: 1129199175
Needle Valve for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 1.75mm
Application:Part #: 6845110
Buggy Windshield Mounting Kit (Windshield not Included)
Application:Part #: 261801804
Inner Post For Side Panel, Full Height
Application:Part #: 111837211
This seal goes between the handle and the body.
Application:Part #: 143845321A
Non Pop-Out Quarter Window Seals
Application:Part #: 211711149
This plate sits under the shifter to keep you from hitting reverse gear when you shift into 2nd.
Application:Part #: 1198036
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 1501541
These control arm bushings on IRS control arms are a good way to stiffen up the flex that goes into the arms.
Application:Part #: 1129044E
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 311837658A
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
Application:Part #: 1601063A
Empi 4 Spoke, Anthracite, 4x130, 15x5.5"
Application:Part #: 1707135ACH
This is one of the original bumper options that was used on the first Cal-Look Bugs back in the 70's.
Application:
This kit comes with everthing you need to eliminate your vent window, tempered glass, felt window channels, inner and outer snap in scrappers.
