Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the rubber snubbers that are in between the front torsion bar arms. They prevent the arms from topping out or bottoming out on king and link pin front ends. To get the old ones off use a sharp knife. When installing the new ones squirt some oil into the rubber and push them on.
Bus (Type 2): 68-79
No customer reviews for the moment.
Part #: 111813155
Metal Channel for Engine to Body Seal
Application:Part #: 141971115
The electrical harness runs everything on the car.
Application:Part #: 113611023B
This hydraulic cylinder feeds all the wheel cylinders.
Application:Part #: 6945201A
These lights work well on off road cars. With Amber Lens
Application:Part #: 1119027BK
This small fan shroud came on the 36hp motor.
Application:Part #: 1251009SS
EMPI Stainless Steel PHAT Boy Muffler
Application:Part #: N120112
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: N130101
Overhead Air Vent Shutter Set Screw and Lock Nut
Application:Part #: 002141701
This shaft holds the throw-out bearing in place.
Application:Part #: 151837628A
For convertibles, this is the upper pin that the vent wing pivots on.
Application:Part #: 113953541GY
Turn Signal Switch Knob, Gray
Application:Part #: 141953161AAM
These are the lenses that go over the front turn signal bulb holders.
Application:Part #: 131415813E
These are the ball joints on the tie rods.
Application:Part #: 153871373A
This is a sleeve that goes in the front window frame for the guide pins to sit in.
Application:Part #: 1115458
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 1198094C
94mm Mahle Barrels
Application:
