Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the ball joints on the tie rods.
These are the ball joints on the tie rods. To check the tie rod ends see: TIE RODS WITH ENDS. On some stock tie rods, the ends don't come off and you will need to replace the entire tie rod. We suggest you replace it with an adjustable one. We only carry adjustable tie rods.
No customer reviews for the moment.
Part #: 111498100A
The main reason to replace these clamps is because you've destroyed the old ones getting them off.
Application:Part #: 113127303
The fuel pump sits on this little stand and it's also the guide for the push rod.
Application:Part #: 111881363
This is the padding that sits on top of the springs of the seat.
Application:Part #: 251501203E
A new assembly consists of a new axle with CV joints and boots, ready to install.
Application:Part #: 133711717B
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 1611750E
These stainless steel braided flex lines don't swell like the original rubber hoses and they make the undercarriage look a lot nicer.
Application:Part #: 211405371BWG
These are reconditioned arms with new ball joints pressed in. They are sold on an exchange basis. If you would like to order these before sending your old arms in, please add part number 211405371WGC to your order. That is the core charge. Once you send back your old arms we will refund that amount, providing your arms are good.
Application:Part #: 113407171AX
Camber Bolt and Bushing Kit
Application:Part #: 241853597A
Vent Louver Trim Set, High Polish Stainless Steel
Application:Part #: 111957000
Speedometer Warning Light Kit
Application:Part #: 1411107
2" Narrowed Leaves for Link Pin, 1 Set (2 sets required)
Application:Part #: 6411106
Thru Rod, Stock Width Beam, 40.5" Long, Boxed
Application:Part #: 113131617C
This is a smog device.
Application:Part #: 211813164A
This is what the battery sits on.
Application:Part #: 1105305
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 151871211B
These bows face the outside of the quarters.
Application:
These are the ball joints on the tie rods.