Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This hydraulic cylinder feeds all the wheel cylinders.
This hydraulic cylinder feeds all the wheel cylinders. After installing a new one make sure the rod that pushes the plunger is adjusted correctly. When adjusting it you can't see the measurement but you can feel it. The rod should have about an 1/8" of free play before it starts pushing. If it's too tight it will not allow the fluid to travel back to the reservoir locking up the brakes usually in the middle of an intersection.
No customer reviews for the moment.
Part #: 113611817
This is the grommet for the reservoir line(s) where they go into the master cylinder. 17.5mmx4.5mm
Application:Part #: 803611755
These are the metal brake lines found throughout the car.
Application:Part #: 113611781D
These are the metal brake lines found throughout the car.
Application:Part #: 211611775B
This flex hose goes from the metal brake line on the rear fork to the metal brake line on the axle tube.
Application:Part #: 311611701B
This flex hose goes from the metal brake line to the front wheel cylinder. m/f 335mm
Application:Part #: 113611301G
The reservoir holds the brake fluid for the brake master cylinder.
Application:Part #: 113611195
This boot is on the plunger end of the master cylinder, keeping dirt out of the master cylinder..
Application:Part #: 211405668
Pair of Spindle Nuts
Application:Part #: 113611801A
Brake fluid reservoir to Steel Line Hose
Application:Part #: 211837235ABK
This plastic "donut" goes under the window crank or door handle to prevent the door panel from getting ripped.
Application:Part #: ECX43
ECP part numbers are for the regular crimp style electrical ends.
Application:Part #: 113827503F
This is the rear handle that opens the engine lid.
Application:Part #: 113953042N
This is the whole unit, lens and bulb holder.
Application:Part #: 215703705A
These large panels box in the frame on buses with sunroofs or door on both sides.
Application:Part #: 1857228BK
These panels go in the dash so you can install gauges.
Application:Part #: 311831131BK
Pinch Welt, Door Opening on Body, Both Sides
Application:Part #: 1129513
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 112950502IDA
Stack Hold Down Screw and Washer
Application:Part #: T1101026
If you are going to rebuild your own motor it is a good idea to get an engine stand.
Application:Part #: 2513002
KYB's are the best selling monotube replacement shock in the U.S.A..
Application:Part #: 1101474
These covers look good but have a tendency to leak.
Application:Part #: 151801132B
These are the replacement rails for convertibles.
Application:Part #: 113827503A
This is the rear handle that opens the engine lid.
Application: