Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This hydraulic cylinder feeds all the wheel cylinders.
This hydraulic cylinder feeds all the wheel cylinders. After installing a new one make sure the rod that pushes the plunger is adjusted correctly. When adjusting it you can't see the measurement but you can feel it. The rod should have about an 1/8" of free play before it starts pushing. If it's too tight it will not allow the fluid to travel back to the reservoir locking up the brakes usually in the middle of an intersection.
No customer reviews for the moment.
Part #: 191611349A
This cap sits on the top of the brake fluid reservoir filler hole.
Application:Part #: 251611301K
Dual Circuit Brake Fluid Reservoir
Application:Part #: 111837685
Vent wing tension clamp, each
Application:Part #: 151871400A
Convertible Top Chrome Molding Kit
Application:Part #: 021119627B
Fresh Air Hose Grommet
Application:Part #: 151701061M
Floor Plate, Left, Convertible only
Application:Part #: 311945191A
This seal goes between the tail light housing and the body of the car..
Application:Part #: 153863706
This is a full carpet kit.
Application:Part #: JC23200
Jaycee Fuel Pump Block off w/ AN 10 Fitting, Red
Application:Part #: 113115181A
This is the plate on the bottom of the motor.
Application:Part #: 1119303BK
These cylinder head tins sit under the fan shroud.
Application:Part #: 039101061D
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 113863374
These rear kick panels go between the rear seat frame and floor.
Application:Part #: 251615108
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: 1B09001YL
These are like the transparent caps, not that great but they look cool.
Application:Part #: 1117012
These bolt on mounts allow you to bolt the filter adapter under the driver's side fender or hang it off the exhaust flange..
Application:Part #: 1115610RD
Billet Dipstick, Red
Application:Part #: 1601054
Empi Dish, Silver, 4x130, 5.5"x15"
Application:
This hydraulic cylinder feeds all the wheel cylinders.