Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn. To inspect the rods, have a friend turn the steering wheel back and forth a little while you place your hand on the top of one of the tie rod ends. If you can feel the end jump up and down before it pushes or pulls, it's bad. On some tie rods it's possible to change just the ends. On other tie rods, the ends are swedged on and the whole tie rod will need to be replaced. Usually you replace just the end unless the rod is bent or has the swedged ends.
No customer reviews for the moment.
Part #: 311141031D
This disc transfers the power from the motor to the transmission.
Application:Part #: 151871349C
This sels the leading edge of the top to the front window frame..
Application:Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 113611053B
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 1105254BK
This is a crank pulley for an upright motor.
Application:Part #: 1615107C
Replacement Rear Brake Bracket for Kit # 1615108A, 1615108, Each
Application:Part #: 1129027
This raises a stock 28/30PICT carburetor to clear the 12 volt alternator or generator..
Application:Part #: 221867504
This is the vinyl covering for the inside roof and sides of the Bus.
Application:Part #: 151867507
This is the vinyl covering for the inside roof and sides of the Bug.
Application:Part #: 1115431
This hex drive replacement plug is for the case relief spring(s).
Application:Part #: 313877471
Sunroof Handle Screw
Application:Part #: 111953041A
This is the whole unit, lens and bulb holder.
Application:Part #: 113405311D
These are the front spindles that your brake discs mount to.
Application:Part #: 113611805B
Metal brake line
Application:Part #: 620107210
Spun aluminum gas tanks for Buggies, come with either end fill or center fill option.
Application:Part #: 04010
These are the parts found in the distributor.
Application:
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.