Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:These mounts made of urethane never wear-out.
These mounts made of urethane never wear-out. The good thing about them is that they don't break; the bad thing is they do transmit more noise through the tunnel. We urge you to use these mounts along with the front and rear transmission straps if you are running a larger motor.
Bug (Type 1): 61-72
Type 3: 64-68
Ghia: 56-72
Thing: 73-74
Race/Off-Road: 61-72
No customer reviews for the moment.
Part #: 111301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 211301265A
These rubber mounts hold the transmission in place.
Application:Part #: 1311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 1301150
Bolt on Center Transmission mount, Urethane stops included
Application:Part #: 113301189F
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: N122391
Transmission Cradle Bolt Washer
Application:Part #: 311301343
Sleeve
Application:Part #: 113301229A
This is the front of the transmission that houses the shift lever.
Application:Part #: 1301265L
Urethane Front Transmission mount with Hardware
Application:Part #: 311301265BFA
Transmission mount, Front
Application:Part #: 111301289B
This boot goes around the nose cone to seal up the hole where it comes through the pan.
Application:Part #: 1301266
Trans Axle Adapter Kit
Application:Part #: 113517191
Swing Axle Fulcrum Plates
Application:Part #: 113517289A
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 001301209
Nose Cone Bushing, Front, Late
Application: