Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn. To inspect the rods, have a friend turn the steering wheel back and forth a little while you place your hand on the top of one of the tie rod ends. If you can feel the end jump up and down before it pushes or pulls, it's bad. On some tie rods it's possible to change just the ends. On other tie rods, the ends are swedged on and the whole tie rod will need to be replaced. Usually you replace just the end unless the rod is bent or has the swedged ends.
No customer reviews for the moment.
Part #: 1115351BIL
Filter Replacement for Billet System 1
Application:Part #: 311837658A
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
Application:Part #: 1115183BL
This plate is made out of a solid piece of aluminum. Blue
Application:Part #: 111953041A
This is the whole unit, lens and bulb holder.
Application:Part #: 113881633C
This knob and guide allows you to release the back of the front seat.
Application:Part #: 6415061B
It's super compact, light weight and easy to mount on Buggies or Sand rails.
Application:Part #: 261801477
Single Cab Pickup Rear Bed Section 61"x36"
Application:Part #: 1611701C
Stainless Steel Braided Line, 340mm, Female/Female Ends (Pair)
Application:Part #: 211707136B
These brackets hold the bumpers on.
Application:Part #: 113971235A
This is the strap that goes from the negative post of the battery to the pan of the car.
Application:Part #: 113863711
This is a full carpet kit.
Application:Part #: 1127105ALMA
Fuel AN Fitting, 48 IDA
Application:Part #: 1955441BIL
Billet Radio Knobs, Push-on, Pair
Application:Part #: 1805053
This tray mounts behind the rear seat.
Application:Part #: 1127026PG
Fuel Pressure Gauge, 0-15 PSI, 1 1/2"
Application:Part #: 6501149108F
These boots and flanges are designed for axles with very long suspension travel.
Application:
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.