Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn. To inspect the rods, have a friend turn the steering wheel back and forth a little while you place your hand on the top of one of the tie rod ends. If you can feel the end jump up and down before it pushes or pulls, it's bad. On some tie rods it's possible to change just the ends. On other tie rods, the ends are swedged on and the whole tie rod will need to be replaced. Usually you replace just the end unless the rod is bent or has the swedged ends.
No customer reviews for the moment.
Part #: 1823021
This is a dress-up kit for the front and rear air intakes on your bug..
Application:Part #: 043251187B
Tail pipes route the exhaust out of the back of the stock muffler..
Application:Part #: 143845321A
Non Pop-Out Quarter Window Seals
Application:Part #: T1129028
Some carb combo's are tricky to sync, like kadrons that have a stud sticking up.
Application:Part #: 113201635
Fuel Tank Clamp
Application:Part #: SR28X
This is what starts the car.
Application:Part #: 211255719E
Heater Tube Insulating Cover, Pipe to Heater Box
Application:Part #: 111941173A
Parking Light Bulb Holder
Application:Part #: N137761
Here are some of the replacement parts for your stock carburetor..
Application:Part #: 6857645
This billet foot rest keeps your passengers feet planted while they hold on for some off-road fun..
Application:Part #: JC86160
Jaycee Billet 4.5" Crank Pulley for Drag Cars, Red
Application:Part #: 131601155
Beauty rings fit under the hubcap to improve the look of your stock rim.
Application:Part #: N119511
Sunroof Cover and Headliner Finishing Screw
Application:Part #: 1105254BK
This is a crank pulley for an upright motor.
Application:Part #: 211721629
Pivot Pin for Accelerator Pedal Hinge
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.